Browse By

Category Archives: CME

Cisco CME – Drop Conference when initiator Disconnects

Cisco CME – Drop Conference when initiator Disconnects Disconnect conference bridge when initiator drops from the conference call Have you ever been asked a question on Cisco Call Manager Express – How to configure Cisco CME in a way that when initiator of the conference disconnects/leaves

uccollabing.com

Top and Most useful Cisco Voice IOS Commands

Top and Most useful Cisco Voice IOS Commands If you are working as a Voice Engineer or planning to learn Voice or may have an interview, the below list of commands are the ones which are most commonly used by Voice Engineers. These commands are

No Thumbnail

Cisco IP Phone Serial Grabber Tool

Hi All, Do you just want to collect Cisco IP Phone Serial Number and update your inventory? If yes, then there is a tool which works for Cisco Unified Communication Manager as well as Cisco Call Manager Express. This works great for the Phone Models

No Thumbnail

Simulate PRI E1 T1 Calls

Hi All, Don’t have a real PRI? Want to simulate E1/T1 PRI on your lab? If yes, then here is the solution. You need two routers, let’s say 2800 series router which has E1/T1 Card connected on each. One router would be Service Provider’s router

No Thumbnail

Cisco Call Manager Express – SIP/SCCP Configuration

Hello Everyone, While testing further i had a thought of preparing a lab scenario where i have SCCP Phones and SIP Phones registered in the same CME and will initiate a call within the lab scenario. PS:- I have implemented the scenario using GNS3 and

No Thumbnail

Cisco Call Manager Express (CME) – Basic Configuration

Hello Everyone, I know the readers are quite experienced and they would not be interested in this post as this will guide to build the basic configuration of Call Manager Express. I assume that basic configuration are done like assigning of IP Address on the

Show Buttons
Hide Buttons