Python Automation on Cisco Router and Switches using SSH Today in this article we will see how a python script automatically logs into a Cisco Router using ssh and configure a loopback interface. Pre-Requisite is to install Netmiko using the command “pip install netmiko” on
Automate IOS upgrade for Cisco Routers and Cisco Switches in Bulk I am new to python and have written this script based on my experience so far with python and I am sure that this script can be optimized and enhanced in much better way.
Hello All, H323 RAS Messages exchanged between the endpoints and the Gatekeeper. In the last post, we configured the Gateway (CME) and Gatekeeper. Today, let’s discuss about the RAS Messages exchanged between the endpoints and the Gatekeeper. Gatekeeper Discovery GRQ (Gatekeeper_Request) A message sent by
Run Python Automation Script to fetch Cisco Routers and Switches details in Bulk Today in this article we will see how to use a python script to get Cisco router and Cisco switch status in bulk. The details includes “hostname, uptime, current version, current image, serial
TCP UDP Port Usage – CUCM Voice Gateway and Gatekeeper It is very important to know the port numbers being used by the devices we work on as it makes life easier. If you are aware of the port numbers, it becomes little easier to
A Gatekeeper is an H.323 device that provides services like Address Translation, Bandwidth Management, Accounting and Dial Plans that helps to centralize in order to provide scalability. Let’s say, you have 5 sites with different dial-patterns/plans and you might want to route the calls, imagine
Hello All, Why Gatekeeper Redundancy? – There might be few scenarios where for some reason the router might go hard down or the link. If the Gatekeeper is down, the inter-cluster calls will not work if until and unless the GK comes up. In those