How to configure Single number reach ?

CUCM

Cisco Unified Mobility application known as Mobile Connect, commonly called Single Number Reach (SNR), provides Cisco Unified Communications users with the ability to be reached via a single enterprise phone number that rings on both their IP desk phone and their cellular phone (Remote Destination), simultaneously. Mobile Connect users can pick up an incoming call on either of their desk or cellular phones and at any point and can move the in-progress call from one of these phones to the other without interruption.

Pre requisites:

  • User Configuration 
  • Remote Destination Profile Configuration 
  • Remote Destination Configuration
  1. Create an end user (LDAP syn or local user).
(a) Local user creation

2. Make sure you enable mobility under mobility information.

3. Now, associate the user which you have created to the phone under Device –> Phone.

 

4. Create a Remote Destination Profile (RDP) for the end user .

In order to create a new RDP profile, navigate to Device > Device Settings > Remote Destination Profile > Add new

 

Give any name, associate the user Id which you’ve created, give calling search space, rerouting CSS().It is also important to note that the CUCM attempts to reach the remote destination through the Rerouting calling search Space.

5. Click Add a new DN to navigate to directory number configuration, where you need to specify the directory number of the desk phone with which you need to associate the RDP and then click Save

6. Now for Remote destination number

Specify the Destination number, as this is the number for your Remote destination.

Ensure that the check box, Enable Unified Mobility features, Enable Single Number Reach, Enable Move to Mobile is checked.Single Number Reach Voicemail Policy provides two options Timer control and User Control, of which the former one is default. Under the section Timer information, you can specify the amount of delay before which the Remote Destination should ring.

In case if the Remote Destination is required to ring immediately, you should set the Wait* as zero.

It is also important to calibrate the time in which the service provider of the remote destination sends the call to the voice-mail of the remote destination. The Stop ringing this phone after value should be set lesser then that to ensure that 
call does not go to the voicemail of the cell phone. This time value is specified against Stop ringing this phone after.

7. Check the checkbox, which is next to the line and click Save.

Hope this would have been informative for you and I’d like to thank you for viewing.

How to configure Single number reach ? was last modified: January 4th, 2018 by kanishka
(Visited 358 times, 1 visits today)

Leave a Reply